Manual

Ensure that the Ego LV1 is switched off. Lay the marker on a
flat surface in front of you with the feed tube furthest away
and with the barrel pointing to the right.
Use a 5/64” (2mm) hex key to remove the two countersunk
screws that hold the rubber grip onto the frame (SEE FIGURE
2A) . Peel the grip to the right to expose the circuit board
within the frame.
Remove the fitted battery by sliding your thumb or finger into
the recess below the battery and levering the battery out of
the frame (SEE FIGURE 2B) .
DO NOT pull on the top of the battery to remove it as this
can cause the battery terminals to bend and will result in a
poor electrical connection.
Fit a 9-volt alkaline battery (type PP3, 6LR61 or MN1604)
into the recess with the battery terminals away from you. The
positive terminal should be on the right hand side, nearest to
the front side of the frame (SEE FIGURE 2C) . Planet Eclipse
recommends using a branded high quality alkaline 9V battery.
Budget and rechargeable batteries may cause performance
issues.
Ensure that all of the wires are within the recess of the frame
and away from the trigger, micro-switch and OPTO sensors
so as not to interfere with their operation. Replace the rubber
grip and screw in the two countersunk screws.
DO NOT OVER-TIGHTEN THE SCREWS.
iNSTALLiNG A 9V BATTERY
FIG 2C
FIG 2A
FIG 2B
USiNG THE EGO LV1 7