User's Manual

FIG 2.4

SWITCHING ON

THE ECLIPSE EGO

At the rear of the frame is the Ego Navigation Console. Press and hold

the button (SEE FIGURE 2.3). After one second the Eclipse Ego logo

will be displayed. Release the button and the display will revert to the

designated run screen (Average Rate of Fire, Peak Rate of Fire, Shot Counter

or Game Timer).

SWITCHING OFF

THE ECLIPSE EGO

Press and hold the button for 1 second. The display will

read OFF. Release the button and re-press it to turn

off the Eclipse Ego. Alternatively when the display reads

OFF, you can also pull the trigger once to turn off the

Eclipse Ego.

FIRING THE

ECLIPSE EGO

Pull the trigger to re the Eclipse Ego. The entire ring sequence is controlled

electronically by the Eclipse Ego circuit board and solenoid, enabling any user

to achieve high rates of re easily.

FIG 2.3

USING THE BREAK-BEAM

SENSOR SYSTEM

To switch off the Break-Beam Sensor System, press and hold the

button for one second (SEE FIGURE 2.4).

The eye on icon in the top left hand corner of the LCD screen will change to

the eye off icon indicating that the Break-Beam sensor has been disabled.

To switch the Break-Beam Sensor System back on, press and hold the

button for one second. The eye off icon in the top left hand corner

of the LCD screen will change to the eye on icon indicating that

the breech sensor has been enabled.

When the Break-Beam Sensor System is enabled, the icon will change

depending on if the system has detected a ball or not. When no ball has been

detected the icon looks like this when a ball has been detected the icon

changes to look like this .

Additional features of the egos Break-Beam Sensor System are covered in full

in the "Using Your Ego" section of this user manual.

NOTE: WHEN TURNING ON THE ECLIPSE EGO, THE BREAK-BEAM

SENSOR SYSTEM IS AUTOMATICALLY ENABLED

QUICK SET-UP

QUICKGUIDE