User's Manual
TYPE
TYPE refers to the style of ramping that the user wishes
to enable when in a ramping mode of re. There are two
options in TYPE:
When a pre-determined rate
of re has been achieved (set
by the KICK IN parameter) the
rate of re ramps to a higher
rate as set by either the ROF
CAP or MAX ROF parameters,
providing the SUSTAIN level is
maintained.
When a pre- determined rate of
re has been achieved (set by
the KICK IN parameter) the rate
of re ramps to an increased
rate of re in proportion to users
current rate of re, providing
it remains above the level
specied in the SUSTAIN
parameter.
To edit the
TYPE parameter scroll through the RAMP SET
Menu until TYPE is displayed. Press the button, the edit
indicators will be displayed and you are now able to edit the
parameter by using either the button or the . When
you have successfully edited the parameter press the to
return to the RAMP SET Menu.
RATE
RATE is a additional percentage of the current rate of
re that is added to the current rate of re to create the
ramping rate of re (assuming that KICK IN and SUSTAIN
requirements are satised). For example if the RATE was set
to 50%, once the KICK IN rate of pulls per second had been
achieved the rate of re would ramp up to an additional 50%
of the current rate of re.
To edit the
RATE parameter scroll
through the RAMP SET Menu
until RATE is displayed.
Press the button, the edit
indicators will be displayed and you
are now able to edit the parameter.
Press the button to increase the
RATE value in 10% increments.
Press and hold the to increase
the RATE value more rapidly.
Press the to decrease the
RATE
value in 10% increments. Press
and hold the to decrease the
RATE value more rapidly.
When you have successfully edited
the parameter press the to return
to the RAMP SET Menu.
NOTE: THE RATE OPTION IS ONLY FEATURED WHEN
LINEAR HAS BEEN SELECTED IN THE TYPE PARAMETER IN
THE RAMP SET MENU.