User's Manual

CLEANING AND
LUBRICATING THE RAMMER
Note: The number of o-rings on the rammer may vary
according to the model of Ego 7 that you have.
Pull the bolt pin upwards so that it disengages the rammer,
allowing the bolt to be removed via the rear of the Eclipse
Ego7 (SEE FIGURE 12.1).
Using a 3/16" hex key, unscrew and remove the rammer cap
at the rear of the Eclipse Ego7 (SEE FIGURE 12.2).
Raise the front of the Eclipse Ego7 and tap the Eclipse Ego7
onto your hand until the rammer falls into the palm of your
hand (SEE FIGURE 12.3).
Thoroughly clean the rammer shaft and all of its seals,
paying special attention to the seal on the middle of the shaft
(SEE FIGURE 12.4), the rear seal (SEE FIGURE 12.4) and the condition of
the bumper at the rear of the shaft (SEE FIGURE 12.6) overleaf.
Replace any worn seals/bumpers using authentic Eclipse
Ego7 spare parts.
WARNING: DE-GAS YOUR MARKER, DISCHARGING
ANY STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER AND AIR SYSTEM TO MAKE THE
MARKER EASIER TO WORK ON.
WARNING
 


