User's Manual

STRIPPING AND
CLEANING THE TRIGGER
Having removed the trigger frame completely from the Ego7
body, use a 1/16” hex key to loosen the trigger pin retaining
set screw at the rear of the trigger (SEE FIGURE 15.1). Use a small
hex key to gently push the trigger pin out of the frame from
one side (SEE FIGURE 15.2). Use a 5/32” hex key to remove the
two screws that hold the bearing carrier in place in the top of
the trigger frame (SEE FIGURE 15.3). Gently pull the bearing carrier
upwards and remove it from the frame (SEE FIGURE 15.4). Clean
the bearings and the bearing carrier to ensure that they are
free from dirt, paint or moisture (SEE FIGURE 15.5).
 

 
