User's Manual

SWITCHING ON
THE EGO8
Press and hold the button (SEE FIGURE 3.1). After one second
the Ego8 logo will be displayed. Release the button and the
Run Screen will be displayed.
SWITCHING OFF
THE EGO8
Press and hold the button until the display shows OFF?
Release the button and re-press it to turn off the Ego8.
Alternatively when the display reads OFF?, you can pull the
trigger once to turn off the Ego8.
FIRING THE EGO8
Pull the trigger to fire the Ego8. The entire firing sequence is
controlled electronically by the Ego8 circuit board, enabling any
user to easily achieve high rates of fire.
THE EGO8 CIRCUIT
BOARD
There are three sockets on the Ego8 Circuit board two of which
are occupied by the BBSS Connector (A) and the Ego8 Solenoid
(B). The third socket on the board (C) is the Auxiliary socket to
which third party products such as loaders and RF transmitters
can be connected using the relevant wiring harness. (SEE FIGURE
3.2)
FIG 3.2
FIG 3.1
C
A
B
10.
QUICK SET-UP