User's Manual

CLEANING THE

BREAK-BEAM SENSOR

SYSTEM

Undo the retaining screw for the Break-Beam Sensor Cover on

the left hand side of the Ego8 using a 5/64" (2mm) hex key (SEE

FIGURE 9.1).

Remove the Sensor Cover to expose the back of the Break-Beam

Sensor unit (SEE FIGURE 9.2). Using a dry cotton bud, carefully

remove any debris, paint or moisture from the back of the sensor

unit and from inside the Sensor Cover.

Lift the BBSS free from the Ego8 body and using another dry

cotton bud, remove any grease or debris build-up from the front

of the sensor unit (SEE FIGURE 9.3).

WARNING: DE-GAS YOUR MARKER, DISCHARGING ANY STORED GAS

IN A SAFE DIRECTION, AND REMOVE THE BARREL, LOADER AND AIR

SYSTEM TO MAKE THE MARKER EASIER TO WORK ON.

WARNING

FIG 9.2

FIG 9.1

FIG 9.3

CONTENTS

ORIENTATION

QUICK SET-UP

USING YOUR EGO8

ADVANCED SET-UP

MENU TREE

MAINTENANCE

FAULT FINDING

SERVICE CENTERS

PARTS LIST

SPARES & ACCESSORIES

49.

MAINTENANCE

QUICK GUIDE