User's Manual

CLEANING THE

INLINE REGULATOR

Note: The internals of your Inline Regulator may vary according to

the model of Ego8 that you have.

Disconnect the macroline hosing from your Inline Regulator

allowing it to be unscrewed from the Front Regulator Mount

(FRM) (SEE FIGURE 10.1).

Turn the Inline Regulator upside down and carefully unscrew the

two sections (SEE FIGURE 10.2).

By ﬁrmly gripping the exposed end of the Inline regulator piston,

carefully remove the piston and spring in its entirety (SEE FIGURE

10.3).

Insert a 1/8” hex key into the adjuster screw in the bottom half of

the Inline Regulator, and wind the screw clockwise through the

bottom section of the regulator body (SEE FIGURE 10.4) and pull

free when it will no longer turn upwards anymore.

WARNING: DE-GAS YOUR MARKER, DISCHARGING ANY STORED GAS

IN A SAFE DIRECTION, AND REMOVE THE BARREL, LOADER AND AIR

SYSTEM TO MAKE THE MARKER EASIER TO WORK ON.

WARNING

NOTE: THE ADJUSTER SCREW CAN ONLY BE REMOVED BY TURNING

IT UPWARDS THROUGH THE BOTTOM SECTION OF THE INLINE

REGULATOR. THE REGULATOR WILL BECOME DAMAGED IT THE

ADJUSTER SCREW IS REMOVED INCORRECTLY.

FIG 10.2 FIG 10.3

FIG 10.1

FIG 10.4

CONTENTS

ORIENTATION

QUICK SET-UP

USING YOUR EGO8

ADVANCED SET-UP

MENU TREE

MAINTENANCE

FAULT FINDING

SERVICE CENTERS

PARTS LIST

SPARES & ACCESSORIES

51.

MAINTENANCE

QUICK GUIDE