User's Manual

CLEANING THE LPR

Note: The internals of your LPR may vary according to the model of

Ego8 that you have.

The Inline regulator can be removed if needs be.

Unscrew the Low-Pressure Regulator cap from the marker body

(SEE FIGURE 11.1).

Remove the LPR piston and rear spring from the LPR cap (SEE

FIGURE 11.2)

Cupping the palm of one hand, turn the LPR cap upside down

and tip the front spring out into your palm (SEE FIGURE 11.3).

Remove the rear spring from the LPR piston and using a dry

cotton bud, carefully clean the seal on the LPR piston (SEE

FIGURE 11.4)

. If the seal is damaged then replace it. Once the seal

has been cleaned, lubricate with a light application of Eclipse

Paintball Gun Oil so that it is ready for re-assembly.

WARNING: DE-GAS YOUR MARKER, DISCHARGING ANY STORED GAS

IN A SAFE DIRECTION, AND REMOVE THE BARREL, LOADER AND AIR

SYSTEM TO MAKE THE MARKER EASIER TO WORK ON.

WARNING

NOTE: THE ADJUSTER PISTON (COLOURED CAP THAT THE FRONT

SPRING RESTS IN) DOES NOT NEED TO BE REMOVED FROM THE LPR

CAP FOR REGULAR MAINTENANCE.

FIG 11.2

FIG 11.4FIG 11.3

FIG 11.1

CONTENTS

ORIENTATION

QUICK SET-UP

USING YOUR EGO8

ADVANCED SET-UP

MENU TREE

MAINTENANCE

FAULT FINDING

SERVICE CENTERS

PARTS LIST

SPARES & ACCESSORIES

53.

MAINTENANCE

QUICK GUIDE