User Manual

FSD DLY

THE FIRST SHOT DROP OFF

DELAY PARAMETER

This parameter sets the amount of time after the last shot before the FSD

COMP is used on the next shot. The first shot after powering on the SL94

will always have FSD COMP. This parameter can be set between 30 and

240 seconds in 10 second increments.

THE SL94

TRIGGER SYSTEMS

The SL94 comes with two complete trigger systems (bearing carrier, trigger,

spring and set-screws) that are interchangeable with the SL94 frame.

For full details of how to change the trigger system in the SL94 please

consult the “Ego9 Trigger Assembly” section in the Ego9 Operators

Manual. If you have any doubts about how to conduct this procedure then

do not hesitate to contact your nearest Eclipse Service Center (see Eclipse

Certified Service Center pages of Ego9 Operators Manual).

For full details of how to adjust your trigger please refer to the Setting th

Trigger Section of the Ego9 Operators Manual.

IMPORTANT

When setting the trigger it is essential to ensure that the electronic trigger

detection is working correctly. When the trigger is fully depressed the

Trigger Detection Indicator (TDI) should point upwards

. When

the trigger is fully released the TDI should point downwards .

For more information, see Understanding the Trigger Detection Indicator

(TDI) and Filter Menu in the Ego9 Operators Manual.

A Spring

B Spring Return Strength Screw

C Trigger Pin Locking Screw

D Front Stop Trigger Screw

E Magnet Return Strength Screw

F Micro Switch Activation Screw

G Rear Stop Trigger Screw

WARNING: REMOVE ALL PAINTBALLS & DE-GAS YOUR MARKER,

DISCHARGING ANY STORED GAS IN A SAFE DIRECTION,

DISCONNECT THE BATTERY & REMOVE THE BARREL, LOADER & AIR SYSTEM

TO MAKE THE MARKER EASIER & SAFER TO WORK ON.

BOLT PLUNGER

BOLT SPRING

#015 NBR 70

BOLT PIN

NOTE: FOR FULL INSTRUCTIONS OF HOW TO ADJUST THE FSD DLY

PARAMETER PLEASE CONSULT THE ADVANCED SET-UP SECTION OF THE

EGO9 OPERATORS MANUAL.

CURE 3 BOLT SYSTEM

FEATURE SUPPLEMENT