Manual

VISIT WWW.PLANETECLIPSE.COM
USING YOUR ETEK2
10
VISIT WWW.PLANETECLIPSE.COM
SETTING UP
Before you can begin to use your Etek2, there are a few necessary
components that are required to enable the Etek2 to function; namely an
air system and a loader of your choice.
INSTALLING A PRESET
AIR SYSTEM
Every Etek2 comes complete with an Eclipse On/Off Purge System
(OOPS) allowing a preset regulator and tank to be screwed straight in
for immediate use. Before
screwing the preset into
the OOPS ensure that
the On/Off knob is wound
out approximately half
way [SEE FIGURE 3.1].
Be careful not to unscrew
the On/Off knob too far
as it will come completely
out of the OOPS. If this
happens, replace the
On/Off knob by screwing it
back into the OOPS body in a clockwise direction.
Screw the preset air system into the OOPS System [SEE FIGURE 3.2] so that
the bottle screws in all the way and is tight. Slowly turn the On/Off knob in
a clockwise direction allowing the On/Off knob System to depress the pin
of the preset air system causing the Etek2 to become pressurized,
providing that there is sufficient air in your tank [SEE FIGURE 3.3].
You have now installed a preset air system onto your Etek2.
NOTE: THE ETEK2 CANNOT BE USED WITH CO2, IT CAN ONLY BE
POWERED BY COMPRESSED AIR OR NITROGEN.
FIG 3.2
FIG 3.3
FIG 3.1