Manual

VISIT WWW.PLANETECLIPSE.COM
USING YOUR ETEK2
14
VISIT WWW.PLANETECLIPSE.COM
THE CONTROL CONSOLE
The Etek2 utilises multi coloured LEDs to display all of the information
that the user requires via the Etek2s Control Console.
Each area of the Control Console is used to perform different
functions and display different information as outlined below:
The Select Pushbutton is used to:
- Switch the Etek2 On and Off.
- Switch the BBSS (eye system) On and Off.
- To scroll through parameters and edit parameters.
The “E” on the Control Console is used to:
- Display the status of the BBSS (eye system).
- Display the value of a parameter in Tens (10 - 90)
The “G” on the Control Console is used to:
- Display the value of a parameter in Units (0 - 9)
- Display the status of the battery.
The “O” on the Control Console is used to:
- Display the value of a parameter in Tenths (0.0 - 0.9)
As a combined unit the “E”, “G” and “O” are also used to:
- Display power up and power down status.
- Display tournament lock status.
- Display that Factory settings have been restored
- To confirm whether a parameter value has been accepted or rejected.
UNDERSTANDING THE BBSS
OPERATION
The Etek2 displays the status of the Break Beam Sensor System using
the “E” area of the Control Console as follows:
Any changes to the Breech Sensor Status will be displayed immediately.
This provides valuable feedback to the user.
An example of this is when you are shooting a string of shots with the
BBSS enabled, the “E” on the Control Console will alternate in colour
from Yellow (no paintball detected) to Blue (paintball detected). In this
instance too much yellow would indicate that your chosen loader cannot
keep up with how fast you are shooting and is consequently slowing
down your rate of fire.
The BBSS is able to switch itself off in the event that a blockage or
contamination prevents it from functioning correctly.This is represented
by a double flashing red light in the “E” area of the Control Console. The
Etek’s ROF will be capped at 10bps. In this instance, the BBSS will switch
itself back on once the blockage is cleared and the correct operation of
the BBSS can then be resumed.
INDICATION BREECH SENSOR STATUS
Flashing Yellow
BBSS enabled (On), no paintball detected
- marker will not fire.
BBSS enabled (On), paintball detected
- marker will fire.
BBSS disabled (Off) - marker will fire.
Blockage detected, BBSS temporarily
disabled (Off) - marker will fire.
Flashing Blue
Flashing Red
Double Flashing Red