Manual

VISIT WWW.PLANETECLIPSE.COM

USING YOUR ETEK2

ADJUSTING YOUR VELOCITY

When using your Etek2, you may wish to change the velocity at which

your Etek2 is firing. This is done by inserting a 1/8" hex key into the

adjuster screw at the bottom of your Etek2 Inline regulator and adjusting

it accordingly (SEE FIGURE 3.11). By turning this adjuster screw clockwise you

decrease the output pressure of the inline regulator and consequently the

velocity, by turning the adjuster screw counter clockwise you increase

the output pressure of the inline regulator and consequently the velocity.

ADJUSTING YOUR LPR PRESSURE

When using your Etek2, you may wish to change the output pressure of

your LPR. This is easily done by inserting a 5/32" inch hex key into the

adjuster screw at the front and adjusting it accordingly (SEE FIGURE 3.12).

By turning the adjuster screw clockwise, you decrease the output

pressure of your LPR and consequently reduce the pressure driving your

rammer back and forth. By turning the adjuster screw counter clockwise,

you increase the output pressure of your LPR and consequently increase

the pressure driving your rammer back and forth.

NOTE: AFTER EACH ADJUSTMENT FIRE AT LEAST TWO CLEARING

SHOTS TO GAIN AN ACCURATE VELOCITY READING. NEVER EXCEED

300FPS.

NOTE: TURNING THE ADJUSTER SCREW OUT TOO FAR WILL CAUSE

IT TO FALL OUT.

FIG 3.11

FIG 3.12