Manual

VISIT WWW.PLANETECLIPSE.COM

ADVANCED SET-UP

THE TOURNAMENT LOCK

The Etek2 has an electronic tournament lock which, once enabled,

prevents the user from making any changes to the operating parameters

of the marker. This tournament lock complies with the rules of all major

tournaments and must be enabled prior to entering the field of play in

order to avoid penalties.

To enable the tournament lock -

1. Unscrew the three screws from the right hand side of the rubber grips

(SEE FIGURE 4.4)

using a 5/64” hex key.

2. Turn on the Etek2.

3. Locate and press the Lock pushbutton on the circuit board

(SEE FIGURE 4.5)

. The Control Console will flash green to indicate that

the tournament lock has been enabled.

4. Replace the three rubber grip screws using a 5/64” hex key.

To disable the tournament lock –

1. Unscrew the three screws from the right hand side of the rubber grips

(SEE FIGURE 4.4)

using a 5/64” hex key.

2. Turn on the Etek2.

3. Locate and press the Lock pushbutton on the circuit board

(SEE FIGURE 4.5)

. The Control Console will flash red to indicate that

the tournament lock has been disabled.

4. Replace the three rubber grip screws using a 5/64” hex key.

NOTE: THE ETEK2 IS SHIPPED WITH THE TOURNAMENT LOCK

DISABLED.

FIG 4.4

FIG 4.5