Manual

VISIT WWW.PLANETECLIPSE.COM

MAINTENANCE

VISIT WWW.PLANETECLIPSE.COM

CLEANING THE BREAK-BEAM

SENSOR SYSTEM

Undo the retaining screw for the Break-Beam Sensor Cover on the left

hand side of the Etek2 using a 5/64" hex key (SEE FIGURE 5.1)(See Figure

6.1)

Remove the Sensor Cover to expose the back of the Break-Beam Sensor

unit (SEE FIGURE 5.2). Using a dry Q-tip, carefully remove any debris, paint

or moisture from the back of the sensor unit and from inside the Sensor

Cover.

Carefully lift the sensor unit free from the Etek2 body and using another

dry Q-tip, remove any grease or debris build-up from the front of the

sensor unit (SEE FIGURE 5.3).

WARNING: DE-GAS YOUR MARKER, DISCHARGING ANY STORED

GAS IN A SAFE DIRECTION, AND REMOVE THE BARREL AND

LOADER TO MAKE THE ETEK2 EASIER TO WORK ON.

FIG 5.1

FIG 5.2

FIG 5.3