Manual

VISIT WWW.PLANETECLIPSE.COM
MAINTENANCE
24
VISIT WWW.PLANETECLIPSE.COM
CLEANING THE INLINE
REGULATOR
Disconnect the hosing from your Inline Regulator allowing it to be
unscrewed from the Front Regulator Mount (FRM) (SEE FIGURE 5.7).
Turn the Inline Regulator upside down and carefully unscrew the two
sections, taking care not to lose the spring from inside the regulator (SEE
FIGURE 5.8).
By firmly gripping the exposed end of the aluminium regulator piston,
carefully remove the piston and spring in its entirety (SEE FIGURE 5.9).
Insert a 1/8” hex key into the adjuster screw in the bottom half of the inline
regulator, and wind the screw clockwise through the bottom section of
the regulator body (SEE FIGURE 5.10) and pull free when it will no longer turn
upwards anymore.
WARNING: DE-GAS YOUR MARKER, DISCHARGING ANY STORED
GAS IN A SAFE DIRECTION, AND REMOVE THE BARREL AND
LOADER TO MAKE THE ETEK2 EASIER TO WORK ON.
FIG 5.7
FIG 5.8
FIG 5.9
FIG 5.10
NOTE: THE ADJUSTER SCREW CAN ONLY BE REMOVED BY TURNING
IT UPWARDS THROUGH THE BOTTOM SECTION OF THE INLINE
REGULATOR. THE REGULATOR WILL BECOME DAMAGED IT THE
ADJUSTER SCREW IS REMOVED INCORRECTLY.