Manual

VISIT WWW.PLANETECLIPSE.COM

MAINTENANCE

VISIT WWW.PLANETECLIPSE.COM

CLEANING AND LUBRICATING THE

RAMMER

Pull the bolt pin upwards so that it dis-engages the rammer, allowing the

bolt to be removed via the rear of the Etek2 (SEE FIGURE 5.26).

Using a 3/16" hex key, unscrew and remove the rammer cap at the rear

of the Etek2 (SEE FIGURE 5.27).

Raise the front of the Etek2 and tap the Etek2 onto your hand until the

rammer falls into the palm of your hand (SEE FIGURE 5.28).

Thoroughly clean the rammer shaft and all of its seals, paying special

attention to the seal on the middle of the shaft (SEE FIGURE 5.29), the rear

seal (SEE FIGURE 5.30) and the condition of the bumper at the rear of the

shaft (SEE FIGURE 5.31). Note: All these pictures are on the next page.

Replace any worn seals/bumpers using authentic Etek2 spare parts.

WARNING: DE-GAS YOUR MARKER, DISCHARGING ANY STORED

GAS IN A SAFE DIRECTION, AND REMOVE THE BARREL AND

LOADER TO MAKE THE ETEK2 EASIER TO WORK ON.

FIG 5.26

FIG 5.27

FIG 5.28