Manual

VISIT WWW.PLANETECLIPSE.COM

MAINTENANCE

VISIT WWW.PLANETECLIPSE.COM

HOW TO STRIP THE ETEK2

Remove the bolt and bolt pin, disconnect any hosing and unscrew the

inline regulator from the front regulator mount as detailed above.

Using a 5/64th" hex key remove the six screws that attach the Etek2 grips

to the Etek2 frame (SEE FIGURE 5.35).

Unplug the solenoid and unplug the Break-Beam sensors from their ports

on the Etek2 printed circuit board (SEE FIGURE 5.36).

Using a 1/8" hex key undo the two frame retaining screws (SEE FIGURE 5.37)

and remove the frame from the Etek2 body, taking care not to damage

any wires.

Free the hose from the barb fitting at the rear of the front regulator mount,

using a pick or other suitable implement (SEE FIGURE 5.38).

WARNING: DE-GAS YOUR MARKER, DISCHARGING ANY STORED

GAS IN A SAFE DIRECTION, AND REMOVE THE BARREL AND

LOADER TO MAKE THE ETEK2 EASIER TO WORK ON.

FIG 5.35

FIG 5.36

FIG 5.37

FIG 5.38