Manual

VISIT WWW.PLANETECLIPSE.COM

MAINTENANCE

Using a 1/8th" hex key, remove the valve plug from the underside of the

Etek2 body (SEE FIGURE 5.39).

Taking the Etek2 body, turn it so that the underside of the front regulator

mount (FRM) is visible, exposing the retaining screw (SEE FIGURE 5.40).

Using a 3/16th" hex key remove the FRM retaining screw and remove the

FRM from the Etek2 body (SEE FIGURE 5.41).

Once the FRM has been removed the LPR body is exposed through the

bottom of the Etek2 body. Slide the complete LPR out of the Etek2 body

(SEE FIGURE 5.42).

Slide the rammer assembly out of the rear of the Etek2, remembering to

remove the valve and valve spring (SEE FIGURE 5.43).

Remove the exhaust valve and valve spring from the rammer assembly,

and inspect the sealing face of both the rammer assembly body and

exhaust valve for

any excessive wear

or damage. If the

exhaust valve or brass

bushed valve guide is

damaged then replace

using authentic Etek2

parts.

You have now stripped

down your Etek2.

FIG 5.39

FIG 5.40

FIG 5.41

FIG 5.42

FIG 5.43