Manual

VISIT WWW.PLANETECLIPSE.COM

MAINTENANCE

VISIT WWW.PLANETECLIPSE.COM

ASSEMBLING THE ETEK2

Having stripped down the Etek2, here is a guide of how best to

re-assemble it.

Clean and lubricate the seal at the back of the LPR body (SEE FIGURE 5.44).

Slide the entire LPR back into the Etek2 body, so that the bottom of the

LPR body lines up with the FRM window in the bottom of the Etek2 body

(SEE FIGURE 5.45).

Insert the FRM, ensuring that all of the seals are in the correct place and

that the FRM lines up with the bottom of the LPR body (SEE FIGURE 5.46).

Using the 3/16th” hex key tighten down the FRM retaining screw to

secure both the FRM and LPR in place.

Lubricate the six seals of the rammer assembly (SEE FIGURE 5.47) and

lubricate the exhaust valve shaft before inserting exhaust valve into the

brass bushed valve guide (SEE FIGURE 5.48).

FIG 5.45

FIG 5.44

FIG 5.46

FIG 5.47

FIG 5.48