Manual

VISIT WWW.PLANETECLIPSE.COM

MAINTENANCE

VISIT WWW.PLANETECLIPSE.COM

...ASSEMBLING THE ETEK2

Carefully thread the solenoid and Break-Beam Sensor leads through the

access hole in the top of the grip frame (SEE FIGURE 5.51), and reattach the

grip frame to the marker, tightening the grip frame screws using a 1/8”

hex key (SEE FIGURE 5.52).

Ensure that the Break-Beam Sensor cables lie neatly in the slots provided

for them in the Etek2 grip frame. Connect the solenoid and the Break-

Beam Sensors into their relevant places on the Etek2 PCB (SEE FIGURE

5.53). Install a 9volt battery by attaching it to the battery connector and

re-attach the Etek2 grips by securing the six grip screws using a 5/64th"

hex key (SEE FIGURE 5.54).

Screw the inline regulator back into the FRM (SEE FIGURE 5.55) and connect

any hosing that was disconnected. Replace bolt and locate bolt pin in the

designated groove in the rammer.

You have now assembled your Etek2.

NOTE: CHECK THAT NO WIRES ARE TRAPPED BEFORE TIGHTENING

DOWN THE FRAME SCREWS.

FIG 5.51

FIG 5.53

FIG 5.54

FIG 5.52

FIG 5.55