Manual

VISIT WWW.PLANETECLIPSE.COM

MAINTENANCE

Thoroughly clean and inspect the spool and its O-rings for any debris

or dirt (SEE FIGURE 5.64). Lubricate the o-rings using Dow 33 or similar

lubricant and re-insert the spool into the solenoid body, with the concave

end towards end A of the solenoid body.

FIGURE 5.65 and FIGURE 5.66 show the difference between the flat end of the

spool and the concave end of the spool.

Replace the two solenoid retaining clips to the sides of the solenoid

body and having ensured that the minifold o-rings are in place; screw

the solenoid back into the correct position on the minifold. For reference,

the end of the solenoid with the metal casing should be towards the rear

of the marker.

Replace the Inline regulator, grip frame and hosing set-up, taking care to

feed the solenoid and BBSS leads through the grip frame correctly so that

they do not get caught or damaged. Having screwed in the three rubber

grip screws to finish the process. You have now stripped and cleaned

your Etek2 solenoid.

FIG 5.64

FIG 5.65

FIG 5.66

CONCAVE

FLAT