Manual

VISIT WWW.PLANETECLIPSE.COM
FAULT FINDING
38
VISIT WWW.PLANETECLIPSE.COM
SYMPTOM
POSSIBLE CAUSE SOLUTION
Although a fresh battery has been fitted, the
Etek2 will not switch on.
The battery does not seem to last very long.
The Etek2 leaks from the Solenoid
The Battery harness wire is damaged.
The battery type is of a low quality.
Check that gasket is intact and seated
correctly in their designated pockets in the
Minifold.
Dirt on Spool of Etek2 Solenoid.
Damaged Eclipse Etek2 Solenoid.
LPR is supercharging causing intermittent
leaking.
Check for damaged or incorrect seals on
Rammer.
Is it leaking from the Barbs?
14 x 2 O-Rings on LPR Body are damaged
causing over pressurising.
Replace the battery harness or circuit board
as necessary.
Use an alkaline or metal hydride battery. Do
not use a low quality or rechargeable battery.
Replace gasket if damaged using Etek2 Parts
kit. Ensure gasket is seated correctly.
Strip and clean solenoid ( See Maintenance
Section ).
Replace Etek2 Solenoid.
Clean LPR Piston seal.
Inspect regulator seal (in LPR Piston) and
regulator seat (in LPR Body). Replace if
necessary.
Replace seals.
Check hose for cuts or replace minifold.
Replace 14 x 2 O-Rings on LPR Body.