Manual

VISIT WWW.PLANETECLIPSE.COM
VISIT WWW.PLANETECLIPSE.COM
9
QUICK SET-UP
SWITCHING ON THE ETEK2
At the rear of the grip frame is the Control Console. Press and hold the
Select Pushbutton [SEE FIGURE 2.3] . Release the Select Pushbutton
when the LED light
up and your Etek2
will begin its power
up sequence.
SWITCHING OFF THE ETEK2
Press and hold the Select push button. Release the Select push button
when all three of the LEDs on the control console turn red. The LEDs will
extinguish one by one and the Etek2 will turn off.
FIRING THE ETEK2
If the Break Beam Sensor System is disabled, pull the trigger to fire
the Etek2. If the Break Beam Sensor System is enabled and there is a
paintball in the breech, pulling the trigger will also fire the Etek2. The entire
firing sequence is controlled electronically by the Etek2 circuit board and
solenoid, enabling any user to achieve high rates of fire easily.
USING THE BREAK BEAM SENSOR
SYSTEM (BBSS)
When the Etek2 is powered up, the Break Beam Sensor System (BBSS)
is automatically enabled.
To switch off the Break Beam Sensor System, push and hold the Select
pushbutton for 0.5 seconds. The “E” on the Control Console will flash red
indicating that the Break Beam Sensor System has been disabled [SEE
FIGURE 2.4] .
To switch on the Break Beam Sensor System, push and hold the
Select pushbutton for 0.5 seconds. The “E” on the Control Console will
flash either yellow (no ball detected) or blue (ball detected) indicating that
the Break Beam Sensor System has been enabled [SEE FIGURE 2.5] .
Additional features of the Etek2s Break Beam
Sensor System are covered in full in the
“Understanding the BBSS Operation” section
on Page 14 of this User Manual.
NOTE: WHEN TURNING ON THE ETEK2, THE BREAK-BEAM SENSOR
SYSTEM IS AUTOMATICALLY ENABLED.
FIG 2.3
YELLOW LIGHT -
NO BALL DETECTED.
BLUE LIGHT -
BALL DETECTED.
FIG 2.4
RED LIGHT -
BBSS DISABLED.
FIG 2.5