Manual

ETEK3 2PIECE BARREL
A
B
D
C
E
Your Eclipse Etek3 comes as standard with a 14 inch 2-piece barrel.
The barrel screws into the body of the Etek3 using a right hand thread
meaning that if you hold the Etek3 pointing away from you the barrel
screws into the body in a counter-clockwise direction.
The barrel comprises of two parts, a barrel back and a barrel front .
The two parts are joined together with a left hand thread meaning that
if you hold the barrel, with the back nearest you, the front unscrews in a
counter-clockwise direction. The bore size of the barrel back is engraved
at the end of the barrel back .
On the barrel back there is a 016 NBR 70 o-ring which prevents the
barrel from vibrating loose from the Etek3 body when the marker is
red. There is also a 015 NBR 70 o-ring on the barrel front helps with
alignment when the two sections are screwed together.
Replace and lubricate these o-rings with Eclipse Grease as necessary.
THE BORE SIZE OF YOUR BARREL MAY VARY ACCORDING TO THE
MODEL OF ETEK3 YOU HAVE
E
D
C
B
A
WARNING: THE ETEK3 WILL ONLY ACCEPT COCKER
THREADED BARRELS SUCH AS THE ECLIPSE SHAFT 3
BARREL. DO NOT USE ANY OTHER TYPE OF BARREL
THREAD.
WARNING
14.
ORIENTATION