Manual

SETTING UP YOUR ETEK3
Before you can begin to use your Etek3, you will need to
attach an air system and a paintball loader.
INSTALLING A PRESET AIR
SYSTEM
Every Etek3 comes complete with an Eclipse On/O Purge
System (OOPS) which provides a direct connection for
a preset air system. Before screwing the air system into
the OOPS ensure that the On/O knob is wound out
approximately half way SEE FIGURE 6.1. Be careful not to
unscrew the On/O knob too far as it will come completely
o the OOPS. If this happens, replace the On/O knob
by screwing it back onto the OOPS body in a clockwise
direction.
Screw the preset air system
1
into the OOPS SEE FIGURE
6.2
so that the bottle screws in all the way and is tight.
Slowly turn the On/O knob in a clockwise direction
allowing the OOPS to depress the pin of the preset air
system causing the Etek3 to become pressurised, providing
that there is sucient air in your tank SEE FIGURE 6.3.
You have now installed a preset air system onto your Etek3.
1
We recommend using a preset air system with a high pressure
output to achieve optimum performance from the Etek3,
however most good quality Low pressure output systems will
also work on the Etek3.
FIG 6.3
FIG 6.2
FIG 6.1
WARNING: MAKE SURE THE MARKER IS TURNED OFF
AND THAT NO PAINTBALLS ARE IN THE MARKER OR
LOADER BEFORE INSTALLING AN AIR SYSTEM.
WARNING
WARNING: ALWAYS RELIEVE ALL RESIDUAL GAS
PRESSURE FROM THE ETEK3 BEFORE UNSCREWING THE
PRESET AIR SYSTEM.
WARNING
WARNING: THE ETEK3 CANNOT BE USED WITH CO2,
IT CAN ONLY BE POWERED BY COMPRESSED AIR OR
NITROGEN.
WARNING
20.
USING YOUR ETEK3