Manual

ATTACHING A LOADER
Using a 5/32” hex key, turn the top screw of the clamping
feed neck counter clockwise SEE FIGURE 7.1.
Release the clamping lever on the feed neck SEE FIGURE
7.2
and test to see if your loader can easily be pushed
into the top of the feed neck. If the loader cannot easily
be pushed into the feed neck, loosen the top screw of
the clamping feed neck a little more by turning it counter
clockwise using a 5/32” hex key SEE FIGURE 7.1.
When you have managed to push your loader into the
clamping feed neck, close the clamp to secure it rmly in
place SEE FIGURE 7.3. If the loader is loose then you will
need to release the clamp, tighten the top screw slightly by
turning it clockwise with a 5/32” hex key to close the clamp.
Repeat this process as necessary to secure your loader in
place.
You have now attached a loader to your Etek3. Once you
have lled your loader and air tank you will then be ready
to begin using your Etek3.
FIG 7.3
FIG 7.2
FIG 7.1
WARNING: DO NOT OVER TIGHTEN THE CLAMPING FEED
NECK AS THIS MAY DAMAGE THE LOADER OR FEED NECK
ITSELF.
WARNING
22.
USING YOUR ETEK3