Manual

UNDERSTANDING THE
BBSS INDICATOR BBSS
The BBSS is able to switch itself o in the event that a
blockage or contamination prevents it from functioning
correctly. In this instance, the BBSS will switch itself back on
once the blockage is cleared and the correct operation can
be resumed.
The BBSS Indicator on the main screen is used to indicate
the eight possible states of the BBSS as follows:
In order for the trigger to be successfully operated it must
rst be released and then pulled. The Trigger Detection
Indicator (TDI) is used to indicate each of the possible
trigger states.
BBSS ENABLED AND BALL DETECTED
The Etek3 can be red at the maximum rate of
re determined by the chosen ring mode.
BBSS SENSOR FAULT HAS BEEN
CLEARED
The sensor has been re-enabled. A ball is
detected and the Etek3 can be red at the
maximum rate of re determined by the
chosen ring mode.
BBSS ENABLED NO BALL DETECTED
The Etek3 cannot be red.
BBSS FAULT HAS BEEN CLEARED
The sensor is enabled. No ball is detected so
the Etek3 cannot be red. To reset the BBSS
icon, use the button to switch o the
BBSS and then back on again.
BBSS DISABLED
The Etek3 can be red at a maximum rate
of re as set by the OFF ROF parameter (see
page 47)
BBSS FAULT DETECTED
The system is disabled. The Etek3 can only
be red at a maximum rate of re of 7.5bps,
regardless of the chosen ring mode.
MICROSWITCH NOT ACTUATED
The micro-switch is not currently actuated, i.e.
the trigger is released.
MICROSWITCH ACTUATED
The micro-switch is currently actuated, i.e. the
trigger is pulled.
UNDERSTANDING THE
TRIGGER DETECTION
INDICATOR TDI
34.
EMORTAL BOARD
34.
EMORTAL BOARD