Manual

OFF ROF
THE RATE OF FIRE WHEN BBSS OFF
PARAMETER
The OFF ROF parameter is used to control how
fast the Etek3 cycles when the Break Beam
Sensor System is disabled. This parameter can
be set between 4.0 and 15.0 balls per second
and should always be set to the slowest speed
of the loading system in use.
RMP SET
THE RAMP SETTINGS MENU
This menu is only available when ramping has been
selected with the MODE parameter and comprises a list of
parameters that control the way in which the Etek3 ramps,
as shown below:
TYPE
THE RAMP TYPE PARAMETER
This parameter is used to select the ramping
style and has the following choices:-
> STEP: Step ramping will cause the Etek3
to shoot in semi-automatic until a number
of trigger pulls, set by PULL NO, have been
made at a minimum pull rate, set by KICK
IN
. At this point the rate of re will step up
to the maximum rate of re as set by MAX
ROF
(or the maximum loader speed if the
ROF CAP parameter is set to o). Ramping is
maintained as long as the user continues to
pull the trigger at a required rate set by SUSTAIN.
> LINEAR: Linear ramping will cause the Etek3 to shoot in
semi-automatic until a number of trigger pulls, set by PULL
NO
, have been made at a minimum pull rate, set by KICK
IN
. At this point the rate of re will equal the rate of trigger
pulls increased by the percentage specied by RATE up to a
maximum rate of re as set by MAX ROF, if the ROF CAP is on.
Ramping is maintained as long as the user continues to pull
the trigger at a required rate set by SUSTAIN.
> CANCEL: Editing is cancelled and no changes are made
to the parameter.
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR ETEK3
ADVANCED SET-UP
EMORTAL BOARD
MAINTENANCE
UPGRADING
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
INDEX
47.
EMORTAL BOARD
EMORTAL BOARD
QUICK GUIDE