Manual
CONTINUED
I
nsert the front spring (silver in colour) into the LPR cap,
so that it rests neatly on the adjuster screw
2
SEE FIGURE
11.5.
Place the gold coloured spring onto the LPR piston and
insert piston and spring into the LPR cap, o-ring end rst
SEE FIGURE 11.6.
Before screwing the LPR cap back onto your Etek3, use a
dry cotton bud to clean the 010 NBR 70 o-ring inside the
LPR body SEE FIGURE 11.7. Lubricate this seal using
Eclipse Grease
Replace the LPR cap by screwing it onto the LPR body in
the Etek3 SEE FIGURE 11.8.
1
The internals of your LPR may vary according to the model of
Etek3 you have.
2
The adjuster screw does not need to be removed from the LPR
cap for regular maintenance.
FIG 11.6 FIG 15.7
FIG 15.5
WARNING: IF YOU ARE AT ALL UNSURE OF PERFORMING
THE MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST ECLIPSE SERVICE CENTRE. SEE PAGES
8081
WARNING
FIG 15.6
FIG 15.8
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR ETEK3
ADVANCED SET-UP
EMORTAL BOARD
MAINTENANCE
UPGRADING
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
INDEX
57.
MAINTENANCE
MAINTENANCE
QUICK GUIDE