Manual

SWITCHING ON THE ETEK3
At the rear of the grip frame is the Navigation Console.
Press and hold the Select button SEE FIGURE 1.1.
Release the Select button when the LEDs light up and
your Etek3 will begin its power up sequence.
1
SWITCHING OFF THE
ETEK3
Press and hold the Select button . Release the Select
button when all three of the LEDs on the Navigation
Console turn red. The LEDs will extinguish one by one and
the Etek3 will turn o.
FIRING THE ETEK3
If the Break Beam Sensor System (BBSS) is disabled, pull the
trigger to re the Etek3. If the Break Beam Sensor System is
enabled and there is a paintball in the breech, pulling the
trigger will also re the Etek3. The entire ring sequence
is controlled electronically by the Etek3 circuit board and
solenoid, enabling any user to achieve high rates of re
easily.
THE ETEK3 LED CIRCUIT
BOARD
There are three sockets on the Etek3 circuit board, the BBSS
connector (A), the Etek3 solenoid connector (B) and the
micro-switch connector (C) SEE FIGURE 1.2.
FIG 1.2
FIG 1.1
ETEK3 LT ETEK3 AM
C
A
B
6.
QUICK SET-UP