Manual
REMOVING AND
ATTACHING THE FRAME
Disconnect any hosing and unscrew the inline regulator
from the front regulator mount as detailed in the Cleaning
the Inline Regulator section of this maintenance guide
(pages 56-57).
Using a 5/64” hex key remove the six screws that attach the
Etek3 rubber grips to the Etek3 grip frame SEE FIGURE
18.1
. Unplug the solenoid and unplug the break beam
sensor system from their connections on the Etek3 circuit
board SEE FIGURE 18.2.
Using a 1/8” hex key undo the two frame retaining screws
SEE FIGURE 18.3 and remove the frame from the Etek3
body, taking care not to damage any wires SEE FIGURE
18.4
.
You have now removed the frame.
FIG 13.7
FIG 18.3
FIG 18.4
FIG 18.2
FIG 18.1
WARNING: DEGAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE THE
BARREL, LOADER, AIR SYSTEM AND ANY PAINTBALLS TO
MAKE THE MARKER EASIER AND SAFER TO WORK ON.
WARNING
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR ETEK3
ADVANCED SET-UP
EMORTAL BOARD
MAINTENANCE
UPGRADING
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
INDEX
61.
MAINTENANCE
MAINTENANCE
QUICK GUIDE