Manual
CONTINUED
Position the trigger so that the hole through the trigger
lines up with the holes in the bearing carrier (SEE FIGURE
19.5)
Then slide the trigger pin in place, tighten the trigger
pin locking screw in the back of the trigger ensuring that
the trigger can still move freely in the bearing carrier.
Gently lower the trigger assembly and bearing carrier into
the frame, taking care not to damage the micro-switch
and ensuring that the trigger is positioned correctly (SEE
FIGURE 19.6)
. Then insert the retaining clip into the frame
on top of the bearing carrier, ensuring the legs of the clip
are sat in the locating holes in the frame wall.SEE FIGURE
19.7
.
You have now stripped and cleaned your Etek3 trigger
assembly.
FIG 19.7
FIG 19.6
FIG 19.5
WARNING: IF YOU ARE AT ALL UNSURE OF PERFORMING
THE MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST ECLIPSE SERVICE CENTRE. SEE PAGES
8081
WARNING
64.
MAINTENANCE