Manual

USING THE EMORTAL
BOARD BREAK BEAM
SENSOR SYSTEM
The Break Beam Sensor System (BBSS) is used to detect
when a paintball is ready to re from the Etek3. If no
paintball is ready then the BBSS will inhibit the Etek3 from
ring. This prevents the Etek3 from ‘chopping’ paintballs
that are not fully loaded into the marker.
To switch o the Break Beam Sensor System, press and
hold the button for 0.5 second SEE FIGURE 3.1.
The break beam sensor system indicator on the top right of
the LCD will change from (enabled) to (disabled).
To switch the Break Beam Sensor System back on, press
and hold the button for one second. The indicator will
change back to .
When the Break Beam Sensor System is enabled, the
indicator will change depending on whether the system
has detected a ball or not. When no ball has been detected
the indicator looks like this when a ball has been
detected the indicator changes to look like this .
Additional features of the Emortal Board’s Break Beam
Sensor System are covered in full on page 34 of this user
manual.
FIG 3.1
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR ETEK3
ADVANCED SET-UP
EMORTAL BOARD
MAINTENANCE
UPGRADING
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
INDEX
9.
QUICK SET-UP
QUICK SET-UP
QUICK GUIDE