Manual

STRAIGHT MACROLINE
FITTINGS
A straight macroline fitting can be found on the inline
regulator swivel and OOPS as shown in
FIGURES
8A & 8B
. These fittings are secured using thread
lock
and DO NOT need to be removed during regular
maintenance.
MACROLINE HOSING
To aid the longevity of your macroline hosing, it is
very important to remove it from and install it back
into the fittings in the correct manner:
Pull back the collet section of the hose fitting and
keep the collet depressed. Pull the macroline hose out
of the hose fitting and release the collet.
Before installing the macroline hose into the fitting
ensure that the end has been trimmed correctly and
is the correct length to ensure a tight fit in the hose
fitting.
IF THE MACROLINE BECOMES WORN, DAMAGED
OR IS THE WRONG LENGTH, REPLACE IT
IMMEDIATELY.
REPLACE THE MACROLINE HOSE WITH THE
FOLLOWING GRADE OR HIGHER -
1/4” OD X 1/8”ID SEMI RIGID NYLON 11
IF UNSURE CONTACT YOUR NEAREST ECLIPSE
SERVICE CENTRE
WARNING
FIG 8A
FIG 8b
CONTENTS
ORIENTATION
QUICK SET-UP
USING THE ETEK4
ADVANCED SET-UP
EMORTAL BOARD
MAINTENANCE
UPGRADING
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES
INDEX
21.
USING THE ETEK4
QUICK GUIDE