Manual

ATTACHING A LOADER
Release the clamping lever on the feed neck
(SEE
FIGURE 10A)
and test to see if your loader can
easily be pushed into the top of the feed neck. If the
loader cannot easily be pushed into the feed neck,
loosen the top screw on the feed neck by turning
it counter-clockwise using a 5/32” hex key
(SEE
FIGURE 10B)
.
When you have managed to push your loader into
the feed neck, close the clamping lever to secure it
firmly in place
(SEE FIGURE 10C). If the loader is
loose then you will need to release the clamping lever,
tighten the top screw slightly by turning it clockwise
with a 5/32” hex key
(SEE FIGURE 10B), then
close the clamping lever. Repeat this process as
necessary to secure your loader in place.
You have now attached a loader to your Etek4. Once
you have filled your loader and air tank you will then
be ready to begin using your Etek4.
DO NOT OVER TIGHTEN THE CLAMPING FEED
NECK AS THIS MAY DAMAGE THE LOADER OR
FEED NECK ITSELF.
WARNING
F IG 10 A
F IG 10b
F IG 10C
24.
USING THE ETEK4