Manual

ADjUSTING THE VELOCITY
When using your Etek4, you may wish to change the
velocity at which your Etek4 is firing. This is done by
inserting a 1/8" hex key into the adjuster screw at the
bottom of your Etek4 inline regulator and adjusting
it accordingly
(SEE FIGURE 12A). By turning this
adjuster screw clockwise you decrease the output
pressure of the inline regulator and consequently
the velocity, by turning the adjuster screw counter
clockwise you increase the output pressure of the
inline regulator and consequently the velocity
1
. On
the bottom of the inline regulator there are engraved
arrows to illustrate which direction to turn the hex key
to make the relevant adjustment.
ADjUSTING THE LPR
PRESSURE
When using your Etek4, you may wish to change the
output pressure of your low pressure regulator (LPR).
This is easily done by inserting a 1/8" inch hex key
into the adjuster screw at the front and adjusting
it accordingly
(SEE FIGURE 12B). However we
recommend that the LPR screw be left set 2 turns in
(clockwise) from the screw being flush with the front
of the LPR cap.
By turning the adjuster screw clockwise, you decrease
the output pressure of your LPR and consequently
reduce the pressure driving your rammer back and
forth. By turning the adjuster screw counter clockwise,
you increase the output pressure of your LPR and
consequently increase the pressure driving your
rammer back and forth.
2
1
After each adjustment fire two clearing shots to gain an accurate
velocity reading. Never exceed 300fps.
2
Turning the adjuster screw in too far will prevent the Etek4 from
firing.
F IG 12 A
F IG 12b
26.
USING THE ETEK4