Manual

UNLOADING THE ETEK4
Securely attach a barrel blocking device such as the
Eclipse Barrel Sock
1
(supplied with the Etek4) to the
marker as shown in
FIGURE 13A.
Turn off the Etek4 electronics by holding down the
button on the back of the frame. When the LED
display turns red then extinguishes, the marker has
been turned off
(SEE FIGURE 13B).
With the Etek4 pointing away from you. De-gas the
marker by turning OOPS knob clockwise until the
OOPS begins to vent air. Only when the OOPS has fully
degassed the Etek4 marker, unscrew the air system
from the OOPS
(SEE FIGURE 13C).
Open the clamping lever on the feed neck and slacken
off the top feed screw if necessary on the feed neck.
Carefully pull the loader out of the feed neck
(SEE
FIGURE 13D)
.
Looking down the feed neck, check to see if there are
any paintballs still in the breech, if there are, turn
the marker upside down while still keeping the barrel
facing away from any persons within firing range
then tip out any paintballs within the breech
(SEE
FIGURE 13E)
.
Next remove the barrel blocking device, and unscrew
the barrel
(SEE FIGURE 13F). Remove any
paintballs within the barrel.
The Eclipse Etek4 has now been unloaded and is
ready for storage.
1
Instruction on using the Eclipse barrel sock can be found on the
sock warning label.
ALWAYS KEEP THE ECLIPSE ETEK4 POINTED IN
A SAFE DIRECTION AND ENSURE ALL PERSONS
WITHIN RANGE CONTINUE TO WEAR FACE
PROTECTION, UNTIL MARKER IS COMPLETELY
UNLOADED AND SAFE.
WARNING
F IG 12b
F IG 13 A FIG 13b
F IG 13C
FIG 13E
FIG 13D
FIG 13F
CONTENTS
ORIENTATION
QUICK SET-UP
USING THE ETEK4
ADVANCED SET-UP
EMORTAL BOARD
MAINTENANCE
UPGRADING
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES
INDEX
27.
USING THE ETEK4
QUICK GUIDE