Manual

THE TOURNAMENT LOCK
The Etek4 has an electronic tournament lock which,
once enabled, prevents the user from making any
changes to the setup parameters of the marker. This
tournament lock complies with the rules of all major
tournaments and must be enabled prior to entering
the field of play in order to avoid penalties.
To enable the tournament lock -
1. Unscrew the three screws from the right hand side
of the rubber grips
(SEE FIGURE 14A) using a
5/64” hex key.
2. Turn on the Etek4.
3. Locate and press the Lock button on the circuit
board
(SEE
A
IN FIGURE 14B). The navigation
console will flash green to indicate that the
tournament lock has been enabled.
4. Replace the three rubber grip screws using a 5/64”
hex key.
To disable the tournament lock -
1. Unscrew the three screws from the right hand side
of the rubber grips
(SEE FIGURE 14A) using a
5/64” hex key.
2. Turn on the Etek4.
3. Locate and press the Lock button on the circuit
board
(SEE
A
IN FIGURE 14B). The navigation
console will flash red to indicate that the tournament
lock has been disabled.
4. Replace the three rubber grip screws using a 5/64”
hex key.
A
FIG 14 A
FIG 14b
CONTENTS
ORIENTATION
QUICK SET-UP
USING THE ETEK4
ADVANCED SET-UP
EMORTAL BOARD
MAINTENANCE
UPGRADING
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES
INDEX
29.
USING THE ETEK4
QUICK GUIDE