Manual

SET UP PARAMETERS
The first five set up parameters will need to be set to
comply with the rules of the field or site at which this
Etek4 is used. It is the user’s responsibility to ensure
that these parameters are correctly set.
THE FIRING MODE
PARAMETER
This parameter is used to control
the firing mode of the Etek4. The
Firing Mode parameter is indicated
by a red light on the navigation
console when you are in the Set Up
Mode. There are three selectable
Firing Modes as outlined below:
1.0 : UNCAPPED SEMI
In this mode the Etek4 will fire
one shot for every pull of the trigger. This mode is
uncapped with the BBSS enabled. If the BBSS is off
then the rate of fire is limited by the Maximum ROF
with BBSS OFF parameter.
2.0 : CAPPED SEMI
This mode is the same as the Uncapped Semi mode,
except that the rate of fire is capped to the Maximum
ROF with BBSS ON parameter.
3.0 : CAPPED RAMP
This mode allows the rate of fire to ramp to a
maximum set by the Maximum ROF with BBSS ON
parameter, once the trigger is being pulled at the
required pulls per second rate set by the Ramp
Kick-in Rate parameter. The number of trigger pulls
has to remain equal or above the Ramp Kick-in Rate
parameter to continue ramping. After the last trigger
pull, the ramp can be restarted with a single trigger
pull within the time set in the RAMP RESTART TIME
parameter.
Certain modes may only be available in certain
countries and on certain models of the Etek4.
THE MAXIMUM ROF
WITH BBSS ON
(CAPPED MODES)
In capped firing modes this
parameter is used to control how
fast the Etek4 can cycle.
The Maximum ROF with BBSS ON
parameter is indicated by a green
light on the navigation console
when you are in the Set Up mode.
This is fully adjustable between 4.0 balls per second
and 15.4 balls per second in 0.1 bps increments.
THE MAXIMUM ROF
WITH BBSS OFF
This parameter is used to control
how fast the Etek4 cycles when the
Break Beam Sensor System has
been disabled.
The Maximum ROF with BBSS off
parameter is indicated by a blue
light on the navigation console
when you are in the Set Up Mode.
This parameter is fully adjustable between 4.0 balls
per second and 15.4 balls per second in 0.1 bps
increments.
This parameter should be set to match the slowest
speed of the loading system in use.
32.
ADVANCED SET-UP