Manual

ROF CAP
THE RATE OF FIRE CAP PARAMETER
The ROF CAP parameter is used to specify
whether or not the Etek4 should have
a limited, or capped rate of fire. When
the ROF CAP is enabled, the maximum
achievable rate of fire is set by the MAX
ROF parameter. Choices for the ROF CAP
parameter are:-
> OFF: Rate of Fire only limited by the
loader.
> ON: Rate of Fire limited to the MAX ROF
parameter value.
> CANCEL: Cancel editing and leave the parameter
unchanged.
If the ROF CAP is switched on, then the MAX ROF
parameter will feature as an item in the Set-Up
Menu. If the ROF CAP is switched off, the MAX ROF
parameter is redundant and omitted from the Set-Up
Menu.
MAX ROF
THE MAXIMUM RATE OF FIRE PARAMETER
The MAX ROF parameter is used to set the
maximum achievable rate of fire from the
Etek4. The value of this parameter can be
adjusted between 4.0 and 22.0 balls per
second in 0.1bps increments.
The MAX ROF parameter will only be
displayed if you have set the ROF CAP
parameter to ‘ON’.
CONTENTS
ORIENTATION
QUICK SET-UP
USING THE ETEK4
ADVANCED SET-UP
EMORTAL BOARD
MAINTENANCE
UPGRADING
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES
INDEX
49.
EMORTAL BOARD
QUICK GUIDE