Manual

OFF ROF
THE RATE OF FIRE WHEN BBSS OFF
PARAMETER
The OFF ROF parameter is used to control
how fast the Etek4 cycles when the Break
Beam Sensor System is disabled. This
parameter can be set between 4.0 and
15.0 balls per second and should always
be set to the slowest speed of the loading
system in use.
RMP SET
THE RAMP SETTINGS MENU
This menu is only available when ramping has been
selected with the MODE parameter and comprises a
list of parameters that control the way in which the
Etek4 ramps, as shown below:
TYPE
THE RAMP TYPE PARAMETER
This parameter is used to select the
ramping style and has the following
choices:-
> STEP: Step ramping will cause the
Etek4 to shoot in semi-automatic until a
number of trigger pulls, set by PULL NO,
have been made at a minimum pull rate,
set by KICK IN. At this point the rate of
fire will step up to the maximum rate of
fire as set by MAX ROF (or the maximum
loader speed if the ROF CAP parameter is
set to off). Ramping is maintained as long as the user
continues to pull the trigger at a required rate set by
SUSTAIN.
> LINEAR:
Linear ramping will cause the Etek4 to shoot
in semi-automatic until a number of trigger pulls, set
by PULL NO, have been made at a minimum pull rate,
set by KICK IN. At this point the rate of fire will equal
the rate of trigger pulls increased by the percentage
specified by RATE up to a maximum rate of fire as
set by MAX ROF, if the ROF CAP is on. Ramping is
maintained as long as the user continues to pull the
trigger at a required rate set by SUSTAIN.
> CANCEL: Editing is cancelled and no changes are
made to the parameter.
50.
EmORTAL bOARD