Manual

(CONTINUED)
Using a dry cotton bud, clean the internal 008 NBR70
o-ring that sits inside the top section of the adjuster
assembly. Then using a small hex key gently apply
Eclipse Grease to the o-ring
(SEE FIGURE 17F)
1
.
At this point if you are maintaining the inline regulator
to fix a supercharging issue, turn to page 58, the
‘Advanced SL3 Inline Regulator Maintenance’ section.
If you are not fixing a supercharging issue then there
is no need to perform this advanced maintenance
procedure.
Re-install the adjuster assembly into the bottom
section of the inline regulator threaded end first.
Apply light pressure to the top of the adjuster
assembly, while using a 1/8” hex turn the adjuster
screw counter-clockwise until is stops at the base of
the inline regulator
(SEE FIGURE 17G). Then turn
the adjuster screw back in 2
1/2
turns to set an inline
regulator output pressure that will not damage the
marker when it is ‘gassed up’.
Take the piston, inspect for damage and clean the 016
NBR70 o-ring at the top, re-lubricating it with a light
application of Eclipse Grease
(SEE FIGURE 17H).
Place the inline regulator spring over the piston, then
insert the piston and spring into the top of the inline
regulator top section
(SEE FIGURE 17I). Holding
the piston and spring in place, screw the top and
bottom sections of the inline regulator together.
Screw the inline regulator onto the Etek4 body in
a clockwise direction
(SEE FIGURE 17j), then
re-connect the macroline hose to the fitting on the
regulator swivel. Basic cleaning of the inline regulator
is complete.
1
If any o-rings are damaged please replace them. Extra o-rings
are available from planeteclipse.com or your local Eclipse Service
Centre.
THE SPRING IN THE ETEK4 INLINE REGULATOR
HAS BEEN DESIGNED SPECIFICALLY FOR USE
WITH THE ECLIPSE ETEK4. USING ANY OTHER
SPRING WILL DAMAGE THE ETEK4 AND VOID
YOUR WARRANTY.
WARNING
IF YOU ARE AT ALL UNSURE OF PERFORMING A
MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST SERVICE CENTRE.
WARNING
F IG 17E F IG 17F
F IG 17HF IG 17G
F IG 17I F IG 17J
CONTENTS
ORIENTATION
QUICK SET-UP
USING THE ETEK4
ADVANCED SET-UP
EMORTAL BOARD
MAINTENANCE
UPGRADING
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES
INDEX
57.
MAINTENANCE
QUICK GUIDE