Manual

PLEASE READ ALL THE WARNINGS
ON PAGES 2 & 3 BEFORE USING THIS
MARKER
SWITCHING ON THE ETEK4
At the rear of the frame is the navigation console.
Press and hold the Select button
(SEE FIGURE
1A)
. Release the Select button when the LEDs
light up and your Etek4 will begin its power up
sequence.
1,2
SWITCHING OFF THE ETEK4
Press and hold the Select button . Release the
Select button
when all three of the LEDs on the
navigation console turn red. The LEDs will extinguish
one by one and the Etek4 will turn off.
FIRING THE ETEK4
If the Break Beam Sensor System (BBSS) is disabled,
pull the trigger to fire the Etek4. If the Break Beam
Sensor System is enabled and there is a paintball in
the breech, pulling the trigger will also fire the Etek4.
The entire firing sequence is controlled electronically
by the Etek4 circuit board and solenoid, enabling any
user to achieve high rates of fire easily.
THE ETEK4 LED CIRCUIT
BOARD
There are three sockets on the Etek4 circuit board,
the BBSS connector
A
, the Etek4 solenoid connector
B
and the micro-switch connector
C
. There is a
tournament lock button in between the BBSS and
micro-switch connectors
D
.Information on the
tournament lock button functionality can be found on
page 29
(SEE FIGURE 1B).
1
When the Etek4 is turned on, the Break Beam Sensor System is
automatically enabled.
2
The colours displayed during the power up sequence may vary
depending on the region the marker was originally purchased.
C
A
B
D
ETEK Am
ETEK LT
F IG 1b
FIG 1A
6.
QUICK SET-UP