Manual

(CONTINUED)
I nsert the front spring (silver in colour) into the LPR
cap, so that it rests neatly on the adjuster screw
1
(SEE FIGURE 19E).
Place the gold coloured spring onto the LPR piston
and insert piston and spring into the LPR cap, o-ring
end first
(SEE FIGURE 19F).
Before screwing the LPR cap back onto your Etek4,
use a dry cotton bud to clean the 010 NBR 70 o-ring
inside the LPR body
(SEE FIGURE 19G). Lubricate
this seal using Eclipse Grease
Replace the LPR cap by screwing it onto the LPR body
in the Etek4
(SEE FIGURE 19H).
1
The adjuster screw does not need to be removed from the LPR cap
for regular maintenance.
IF YOU ARE AT ALL UNSURE OF PERFORMING A
MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST SERVICE CENTRE.
WARNING
F IG 19E
F IG 19F F IG 19G
F IG 19H
60.
mAINTENANCE