Manual

(CONTINUED)
Lubricate all of the seals on the rammer shaft and
inside the rammer cap and replace the rammer
into the rear of the Etek4 body as shown in
(SEE
FIGURE 20G).
DO NOT use Eclipse Grease on the rammer. Only use
Eclipse Gun Oil.
Replace the rammer cap, using the 3/16" hex key to
secure it into the Etek4 body
(SEE FIGURE 20H).
DO NOT over tighten the rammer cap screw.
Noting the position of the rammer in the Etek4 body
(SEE FIGURE 20I), replace the bolt and locate the
bolt pin into the designated groove in the rammer
shaft using the dot on the bolt as a reference guide
(SEE FIGURE 20j).
IF YOU ARE AT ALL UNSURE OF PERFORMING A
MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST SERVICE CENTRE.
WARNING
DOT
FIG 20F
FIG 20G FIG 20H
FIG 20JFIG 20I
62.
mAINTENANCE