Manual

(CONTINUED)
To re-attach the frame follow the instructions below.
Carefully thread the solenoid and break beam sensor
system wires through the access holes in the top of
the Etek4 grip frame
(SEE FIGURE 22E) and re-
attach the grip frame to the marker body by tightening
the two grip frame screws using a 1/8” hex key
(SEE
FIGURE 22F)
.
Ensure that the break beam sensor system cables lie
neatly in the slots provided for them on the inside of
the Etek4 grip frame and connect the solenoid and
the break beam sensors to their relevant connections
on the Etek4 circuit board
(SEE FIGURE 22G).
Adjust both the solenoid wires and the break beam
sensor system wires so that they sit neatly within the
grip frame away from the micro-switch arm
(SEE
FIGURE 22H)
.
Re-attach the Etek4 rubber grips to the frame by using
a 5/64” hex key to replace the 6 grip screws.
IF YOU ARE AT ALL UNSURE OF PERFORMING A
MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST SERVICE CENTRE.
WARNING
FIG 22E
FIG 22F
FIG 22G
FIG 22H
CONTENTS
ORIENTATION
QUICK SET-UP
USING THE ETEK4
ADVANCED SET-UP
EMORTAL BOARD
MAINTENANCE
UPGRADING
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES
INDEX
65.
MAINTENANCE
QUICK GUIDE