Manual

THE ETEK4 TRIGGER
ASSEMBLY
Having removed the trigger frame completely from the
Etek4 body (see page 64), remove the retaining clip
that holds the bearing carrier in place in the top of
the frame, this is best done using some pointed nose
pliers to pinch the clip and lift free from the frame
(SEE FIGURE 23A).
Gently lift the bearing carrier and trigger assembly
free from the frame taking care not to damage the
micro-switch
(SEE FIGURE 23B).
Using a 1/16” hex key, loosen the trigger pin retaining
set screw in the back of the trigger
(SEE FIGURE
23C)
. Use a small hex key to push the trigger pin out
of the bearing carrier from one side
(SEE FIGURE
23D)
.
Clean the trigger and bearing carrier thoroughly and
also clean the space within the frame that the trigger
sits into.
DE-GAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER, AIR SYSTEM AND ANY
PAINTBALLS TO MAKE THE MARKER EASIER AND
SAFER TO WORK ON.
WARNING
FIG 23b
FIG 23A
FIG 23D
FIG 23C
66.
mAINTENANCE