Manual

SWITCHING ON THE ETEK4
EMORTAL BOARD
To switch on the Etek4 press and hold the button
until the screen lights up and the Emortal board
begins its power up sequence
(FIGURE 2A).
1,2
SWITCHING OFF THE ETEK4
EMORTAL BOARD
Press and hold the button until the display shows
TURN OFF. Release the
button and re-press it to
turn off the Etek4.
FIRING THE ETEK4
If the Break Beam Sensor System (BBSS) is disabled,
pull the trigger to fire the Etek4. If the Break Beam
Sensor System is enabled and there is a paintball in
the breech, pulling the trigger will also fire the Etek4.
The entire firing sequence is controlled electronically
by the Etek4 Emortal board and solenoid, enabling
any user to achieve high rates of fire easily.
THE ETEK4 EMORTAL BOARD
There are three sockets on the Etek4 circuit board,
the BBSS connector
A
, the Etek4 solenoid connector
B
and the micro-switch connector
C
. There is a
tournament lock button parallel with the middle push
button
D
. Information on the tournament lock button
functionality can be found on page 47
(SEE FIGURE
2B).
1
When the Etek4 is turned on, the Break Beam Sensor System is
automatically enabled.
2
By continuing holding down the button when turning on the
Emortal board the software version number will be displayed.
C
A
B
D
WARNING: THE BACKLIGHT ON THE LCD DISPLAY
TURNS OFF AFTER A PERIOD OF TIME. WHEN
THIS HAPPENS THE MARKER IS STILL ON AND
ABLE TO FIRE.
SEE PAGE 52 ON ADJUSTING THE BACKLIGHT
WARNING
FIG 2A
FIG 2b
CONTENTS
ORIENTATION
QUICK SET-UP
USING THE ETEK4
ADVANCED SET-UP
EMORTAL BOARD
MAINTENANCE
UPGRADING
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES
INDEX
7.
QUICK SET-UP
QUICK GUIDE