Manual

MAINTAINING THE VALVE
ASSEMBLY
Lift the bolt pin and slide the bolt out of the rear of
the marker. Disconnect any hosing and unscrew the
inline regulator from the front regulator mount as
detailed in the Cleaning the Inline Regulator section
of this maintenance guide (page 56-57). Remove the
frame as detailed on page 64.
Take the Etek4 body and turn it so that the underside
of the solenoid assembly, and valve plug are visible
and accessible. Using a 1/8” hex key remove the
screw from the front regulator mount that holds the
LPR body in the marker body
(SEE FIGURE 25A).
Remove the entire LPR assembly, the valve spring
and the exhaust valve from the marker body
(SEE
FIGURE 25B)
. Using a 1/8” hex key remove the
valve plug from the underside of the Etek4 body
(SEE
FIGURE 25C)
. The bottom of the rammer housing
should now be visible through the valve plug hole
(SEE FIGURE 25D). Ensure that the rammer is in
its rear position and taking an L-shaped hex key, place
it down through the bolt slot in the top of the body
so that you can apply light pressure to the end of
the rammer and push it backwards along with the
rammer housing out the back of the Etek4 body
(SEE
FIGURE 25E AND 25F)
.
DE-GAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER, AIR SYSTEM AND ANY
PAINTBALLS TO MAKE THE MARKER EASIER AND
SAFER TO WORK ON.
WARNING
FIG 25b
FIG 25D
FIG 25F
FIG 25C
FIG 25E
FIG 25A
DO NOT PUSH ON THE RAMMER HOUSING
VALVE SEALING FACE TO REMOVE THE RAMMER
HOUSING FROM THE BODY. DOING SO MAY CAUSE
IRREPARABLE DAMAGE TO THE SEALING FACE.
WARNING
70.
mAINTENANCE